Commissioning
²
Fasten the device to a symmetric DIN rail as per EN 50022.
²
Check that the operational data match the values on the name plate.
²
Do not make any changes to the device.
²
Carefully screw the fiber-optic connections (hand-tight).
²
Insert and screw the existing RS232 connector in position.
²
Attach the connectors of the auxiliary voltage to the terminal V
aux
(DC: L+/L- or AC: A/N).
²
Connect the the other contacts such as the binary inputs and command outputs to the terminals.
²
Switch on the auxiliary power supply.
After connecting the auxiliary power supply, the green LED RUN lights up and the device is ready for opera-
tion.
4.3
Assembly and Commissioning
4.3 Commissioning
Accessories, Binary signal transmitter 2-channel, Manual 35
C53000-G9050-C607-1, Edition 09.2019
To Next Page
Loading...
