ACUSON Freestyle User Manual 3-7
Setup
System
The System page provides access to information about your product’s hardware and software
conguration as well as installed options, including the following:
■ Battery Status and Charge Levels for the system (console), left and right charger bays, and
the active probe
■ System information including:
– System serial number
– Software version number
– License number
– Installed options
– Subsystem circuit board information
■ Image Controls (see “Setting Image Controls” and “Removing Patient Information from
Images”).
■ Administrative Options: for more information see, “Administrative Options” on page 3-8.
Getting Help and Service Support
Press the HELPDESK Soft Key to enter contact information for your local Service support
representatives. Your Siemens Service Representative may access additional system
information from the Helpdesk page.
Closing the Active Page
To close the active page select the CANCEL option.
Setting Image Controls
Using the cursor and the Trackball, click on the slider tab using the left Trackball key to adjust
the following:
■ Image Size: use the drop-down box to select the image size.
■ Cine Playback: set the length of time of multi-frame cine loops played back in real-time
scroll memory.
■ Monitor Brightness: move the slider bar to adjust the brightness of the monitor.
■ Capture Quality: set the quality of JPEG-captured images.
– For higher quality images, move the slider bar to the right.
– For lower quality images, move the slider bar to the left.
Removing Patient Information from Images
The Study Anonymity option allows you to remove patient information from images saved
as either JPEG or DICOM. Make the scan anonymous by excluding either the Patient ID
(Identication), the Patient Name, or both. Default setting: the anonymizing features are
turned off; Patient Name and ID are displayed on saved images.
NOTE: These settings do not remove the Patient Name and ID from the DICOM data stored with the
study.
To Next Page
Loading...
