5-6 ACUSON Freestyle User Manual
Scanning
Wireless Probe Operation
To operate the system probe in wireless mode, insert a charged probe battery pack into the
probe.
NOTE: The battery pack is keyed to prevent improper connection. Do not use force
when inserting the probe battery pack.
Probe and battery; line up battery connectors with probe connectors
With the system power ON, turn the probe on by continuously pressing the two circular on-
probe buttons. When power has been turned on for the probe, you will hear a beep from the
probe. The system and the probe will automatically connect.
Connecting More Than One Wireless Probe
To use more than one probe in wireless mode during an exam:
1. Turn the rst probe off by continuously pressing the two circular on-probe buttons, thereby
disconnecting it from the console.
2. Connect to the second probe.
NOTE: If a Probe is connected to the console with the probe Cable Adapter, you
will need to disconnect it to make a wireless connection to another probe. You can
disconnect it either at the probe or the console end.
To Next Page
Loading...
