Siemens AlgoRex CS1140 - Manual Call Point; Input;Output Modules

Activating Sinteso devices
43
Building Technologies 008726_e_en_--
Fire Safety 06.2017
19.2 Manual call point
1
2
Item Manual call point Procedure
1 FDM.. 'KAC' version – Insert test key
– Wait until the response indicator flashes
– Remove test key again
2 FDM11... 'DIN' version – Use key to open doors
– Press button firmly
– Wait until response indicator flashes
– Lock doors again
19.3 Input/output modules
3
1
2
Item Device type Procedure
1 FDCI...
FDCO…
FDCIO…
– Connect connection cable
– Perform corresponding function
– Remove connection cable
 siehe Dokument 007227 / 009718
Activating an input influences the behavior of the fire control panel and/or third-party devices
Activating of output via FDUD29x is not possible. This can be done by activating the corresponding
zone.