Siemens Cerberus PRO FC721 - Detector Line Device Management; Reading in Devices on Detector Line; Detaching a Device; Deleting Device on Person Machine Interface

Commissioning
Detailed commissioning steps
10
102 | 118
Building Technologies
A6V10211100_f_en_
--
Fire Safety
2015
-
12
-
15
10.8.12 Read in devices on detector line
NOTICE
Incorrect order for reading in a
↑
loop
Error when reading in a loop.
The C-NET detector lines are detected as ↑ stubs during the first system startup,
e.g., 'Line' 11, 'Line' 12 (2-digit line number), even if they are connected as a loop.
● For loop with line separator: Switch the second 'Line' / 'Line' 12 off.
● To read in a loop, always select the first 'Line', in this case 'Line' 11. 'Line' 12
is then read in automatically.
A loop is displayed with a 1-digit line number, in this case as 'Line' 1 once it
has been read in.
● Proceed in the same way from 'Line' 21/22 (loop 2) to 'Line' 41/42 (loop 4).
ϖ For ↑ loop with line separator: The second 'Line' is switched off. Link [➙ 99]
1. In the main menu, select 'Topology' > 'Hardware tree' > ↑ 'Station' > ↑ Line
card > ↑ Detector line.
2. Press the 'More Options' softkey and select 'Execute commands'.
3. Select the 'Read in installed devices' command.
 The C-NET devices are read in.
 The following message is shown following successful reading in:
'Command executed'
10.8.13 Detaching the device
If you want to permanently remove a device, uninstall the device and, if required,
the base and connect the wires of the ↑ detector line.
You will find more information about installing and uninstalling in the
documentation for the corresponding device.
10.8.14 Delete the device on Person Machine Interface
1. Mark the corresponding device fault message.
2. Press the 'More Options' softkey.
3. Select the 'Show topology' menu item.
 The logical channel is displayed. For some devices, 'Device' is displayed
directly.
4. Press the 'More Options' softkey.
5. Select the 'Jump to link' menu item.
 The physical channel is displayed.
6. Press the 'Upper level' softkey.
 'Device' is displayed.
7. Press the 'More Options' softkey.
8. Select the 'Execute commands' menu item.
9. Select the 'Remove/delete device' command.
 The control panel deletes the physical representation of the removed device.
 The logical channel element remains in the 'Zone'.