Siemens Cerberus PRO FC721 - Device Removal and Zone Switching; Removing and Re-inserting Devices; Switching Zone On; Permanently Removing C-NET Devices

Remove or replace non
-
stationary C
-
NET devices
Permanently removing non
-
stationary C
-
NET devices
11
108 | 118
Building Technologies
A6V10211100_f_en_
--
Fire Safety
2015
-
12
-
15
11.2.2 Removing devices, performing tasks and re-inserting
devices
Mark the allocation of the devices to the respective
base to avoid additional work
steps.
1. Remove the devices from their bases.
2. Perform the tasks.
3. Re-insert the devices to the respective position.
11.2.3 Switch on zone
1. Select 'Topology' > ↑ 'Detection tree' > 'Area' > ↑ 'Section' > 'Zone' in the main
menu.
2. Press the 'More Options' softkey and select 'Execute commands'.
3. Select the 'On' command.
 The yellow 'ISOLATION' LED goes out.
 The 'Zone' is switched on.
11.3 Permanently removing non-stationary C-NET
devices
You will find additional information about the individual steps on the specified
pages.
1. Switch the C-NET detector line off. Link [➙ 99]
2. Remove the C-NET devices and their bases. Link [➙ 102]
3. Switch the C-NET detector line on. Link [➙ 99]
4. Delete the C-NET devices individually via the Person Machine Interface on the
control panel. Link [➙ 102]
5. Connect the PC to the ↑ 'Station'. Link [➙ 77]
6. Load the configuration from the 'Station' to the PC. Link [➙ 82]
7. Remove the logical elements in Cerberus-Engineering-Tool. Link [➙ 103]
8. Load the configuration from the PC to the 'Station'. Link [➙ 80]
9. Disconnect the PC from the 'Station'. Link [➙ 77]
You can find information about the individual steps in the chapters referenced
below.