1-3
1
Unpacking & Set Up
Do not touch the white
calibration bar.
Inserting Test Strip Table
Insert the test strip table into the
analyzer by holding it by the end
opposite the white calibration bar
and with the white bar facing up.
Push the test table into the
analyzer, pushing it in just over
halfway.
Loading Test Table Insert
The test table insert adapts for use
with a Siemens Healthcare
Diagnostics urinalysis strip or
Clinitest immunoassay cassette.
One side is used for a strip test and
the other side is used for a cassette
test.
6
7
8
Set Up
Interfacing to a Computer
The instrument can send results to
a computer via the serial port
located on the back of the analyzer.
This requires a 9-pin null modem
serial cable that can be purchased
separately at an electronics store or
from your Siemens Representative
(for a list of suppliers see Appendix
A, Local Technical Support
Providers and Distributors).
Do not push the test table fully
into the analyzer as the test table
may become jammed and prevent
the use of the analyzer.
To Next Page
Loading...
