1-5
1
Unpacking & Set Up
Loading the Printer Paper or
Label Roll
1. Open the printer cover by pulling
up on the tab.
2. Open the paper roll compartment
cover by pressing down on its tab
and pulling out.
3. Lift the paper holding arm into
the open, upright position.
4. Place the new paper roll into the
printer paper compartment with the
paper unrolling from underneath
and toward the compartment wall.
5. Feed the paper up along wall
and through the printer. Once you
have approximately 4 inches (or
10 cm) of paper through the printer
then feed the edge of the paper
through the printer cover.
6. Push the paper holding arm
down in to the closed position.
7. Close the printer and paper roll
covers by clicking them into
position.
The analyzer is set up to
automatically print the results (to
turn off the automatic print function
see Section 5, Instrument Set Up).
paper holding arm
The analyzer uses ordinary
thermal paper as provided, or label
stock (for ordering information see
Appendix A, Local Technical
Support Providers and Distributors).
Set Up
11
To Next Page
Loading...
