Siemens CLINITEK Status User Manual

1-7
1
Unpacking & Set Up
Press the on/off button located
on the front of the instrument.
This is the first screen displayed.
The analyzer will run an automatic
system diagnostic test each time it
is turned on.
If this is the first time you have
turned on the analyzer, you will be
led through a Start-Up Wizard, a
quick set-up procedure. If you
require further instruction regarding
the Start-Up Wizard see Section 3,
page 3-1.
Powering Up
Powering Up

Siemens CLINITEK Status Specifications

General

Display	LCD
Sample Type	Urine
Measurement Principle	Reflectance photometry
Type	Urine analyzer
Test Types	Urine test strips
Connectivity	RS232 port
Power Supply	AC adapter
Data Storage	200 patient test results
User Interface	Keypad
Measurement Parameters	Glucose, protein, pH, blood, ketones, bilirubin, urobilinogen, nitrite, leukocytes, specific gravity
Memory	200 results
Operating Conditions	Temperature: 15-30°C, Humidity: 20-80% RH
Measurement Time	Approximately 1 minute