Siemens CLINITEK Status User Manual

1-1
1
Unpacking & Set Up
Clinitek Status
®
+ analyzer
Test table
Test table insert
Unpacking
2 Remove each of the wrappings
and check for the following items:
1 Carefully remove the contents
of the shipping carton. Check the
carton and instrument for visible
signs of damage; if seen,
immediately contact the carrier.
4
1
5
3
2
Paper Roll
Depending on the model you have
received, there may also be a Warranty
Registration Card, Unpacking/Setup Guide,
and/or Quick Reference Guide included.
2
5
If you are using a reagent strip
that has 4 or fewer test pads,
e.g., Uristix
®
4, you must use a short
test table insert. This has to be ordered
separately (for a list of suppliers see
Appendix A, Local Technical Support
Providers and Distributors).
Do not touch the white
calibration bar.
If the power cord is not the style
you need, contact your local
representative (for a list of contacts see
Appendix A, Local Technical Support
Providers and Distributors).
1
Unpacking
3
4
Power Supply

Siemens CLINITEK Status Specifications

General

Display	LCD
Sample Type	Urine
Measurement Principle	Reflectance photometry
Type	Urine analyzer
Test Types	Urine test strips
Connectivity	RS232 port
Power Supply	AC adapter
Data Storage	200 patient test results
User Interface	Keypad
Measurement Parameters	Glucose, protein, pH, blood, ketones, bilirubin, urobilinogen, nitrite, leukocytes, specific gravity
Memory	200 results
Operating Conditions	Temperature: 15-30°C, Humidity: 20-80% RH
Measurement Time	Approximately 1 minute