Siemens CLINITEK Status User Manual

1-4
1
Unpacking & Set Up
Interfacing to the
Clinitek Status Connector
The Clinitek Status connector
allows for Ethernet or wireless
network connectivity, Quality
Control, increased security, bar
code scanning, and additional
features with the Clinitek Status+
analyzer.
This connector provides standard
wired and wireless connectivity of
the Clinitek Status+ system to your
LAN, LIS, HIS, EMR, and allows
for centralized control of all
satellite Point of Care (POC)
Clinitek Status+ analyzers.
Refer to the Clinitek Status
Connect System Operator’s Guide.
Analyzer Software Upgrades
From time to time Siemens will add
new features and make improvements
to the Clinitek Status+ instrument
software.
These software updates will be
available on an electronic memory
card which is inserted into the
software update socket. This socket
is located under the printer cover
and is on the left-hand side of the
printer when you face the back of
the instrument.
Updating the software is a simple
procedure. Instructions for updating
the software on your instrument will
be supplied with the memory card.
Set Up
9
10

Siemens CLINITEK Status Specifications

General

Display	LCD
Sample Type	Urine
Measurement Principle	Reflectance photometry
Type	Urine analyzer
Test Types	Urine test strips
Connectivity	RS232 port
Power Supply	AC adapter
Data Storage	200 patient test results
User Interface	Keypad
Measurement Parameters	Glucose, protein, pH, blood, ketones, bilirubin, urobilinogen, nitrite, leukocytes, specific gravity
Memory	200 results
Operating Conditions	Temperature: 15-30°C, Humidity: 20-80% RH
Measurement Time	Approximately 1 minute