7-1
7
Troubleshooting
General Information
Your Clinitek Status
®
+ analyzer will
operate properly if you follow the
directions for using and cleaning
the instrument.
Error Messages
Error messages will be displayed to
help you when the Clinitek Status+
analyzer detects something which
needs your attention. The format of
this advisory information depends
upon the importance of the
problem and the mode in which the
instrument is being used.
Errors which Disable the
Instrument
If the error is one which prevents
the instrument from being used, all
selection areas on the screen will
be disabled. Taking the corrective
action shown will remove the error
alert screen and allow you to use
the instrument.
Other Errors
There are certain errors which need
to be corrected to enable testing of
samples but do not prevent other
instrument functions from being
used. You will need to carry out the
corrective action to enable testing.
Advisory Messages
Errors of less importance will be
presented via a message on the
main Select screen when this
screen is next displayed. When you
have taken corrective action, the
message will be removed from the
display. If more than one of this
class of error occurs, clearing one
message will enable the next to be
displayed in order of importance to
a user.
Results Alert
If an error occurs during testing and
the test cannot continue because of
the error, this will be presented via
the Results Alert screen. This will
provide details of the error and
show that the test has been
cancelled. The test table will be
extended so that the urinalysis strip
or Clinitest
®
cassette can be
removed.
To correct an error, see the List of
Errors and Advisory Messages located
at the end of this section.
To Next Page
Loading...
Need help?
General
