Siemens CLINITEK Status - Instrument Cleaning and Maintenance; Routine Cleaning Procedures

9-1
9
Cleaning and Maintenance
The test table insert and the test
table should be kept clean if the
analyzer is to operate properly.
Routine Cleaning of Test Table
Insert
1 Remove insert and thoroughly
clean.
2 Rinse both sides of the table
insert under running water.
3 Dry and replace insert.
Periodic Cleaning of Test Table
when Required
1 Remove the test table by
pulling it slowly out of the
analyzer. Lift the test table
insert from the test table, drain
the drip tray if necessary.
2 Wet a cotton-tipped stick with
water and carefully clean test
table (except for white
calibration bar).
Do not autoclave the test
table
or test table insert.
Cleaning
Cleaning
BIOHAZARD Wear personal protective
equipment. Use universal precautions.
Refer to Appendix H for recommended
precautions when working with
biohazardous materials.