changing and connecting modules
Network module (SAFEDLINK)
7
130 | 248
Mounting steps
1. When shielded cables are used, mount the two cable glands (5) with the
nuts (4) on the flange between the fastening tabs (3). These are needed to
secure the shielding.
2. Connect the network module (SAFEDLINK) (1, 6) to the connector X1 (7) at the
desired slot (X13, X12).
3. Fasten the module to the lugs (3) using the two screws (2). Ensure that the
network module is secured correctly in order to prevent open lines.
4. Wire up the system bus according to the pin assignment at X3.
To Next Page
Loading...
