Siemens Gigaset C1 - Setting up a Busy Signal When the MSN Is Being Used (Busy on Busy); Assigning an MSN a Ringer Melody

115
System settings
S1_SL1 / englisch / A31008-M373-B103-1-7619 / settings_bs.fm / 14.06.2004
Setting up a busy signal when the MSN is being used (Busy on Busy)
This setting allows callers to get a busy signal immediately when an external call is
already being made on this MSN, independent of the setting Call waiting.
By factory default, the function is not set.
Assigning an MSN a ringer melody
Each incoming MSN is assigned a ringer melody when setting up. You can change this
assignment for each incoming MSN individually. For a receive MSN you can:
Select one of the available ringer melodies. This means that all handsets will use this
ringer melody to indicate an incoming call to a receive MSN.
v
Open the menu.
sí
Select the menu item and confirm.
s Settings
Select the menu item and confirm.
~
Enter system PIN if required (page 91).
s ISDN settings
Select the menu item and confirm.
s Busy on busy
Select the menu item and confirm (‰ = set).
OK
OK
OK
OK
OK
i
In place of ringer melodies 1–10, you can also assign the "device ringer"
to an MSN. Then the handsets assigned to the receive MSN will use the
ringer melody set on the handset for external calls (page 105).
v
Open the menu.
sí
Select the menu item and confirm.
s Settings
Select the menu item and confirm.
~
Enter system PIN if required (page 91).
s ISDN settings
Select the menu item and confirm.
s Set up MSN
Select the menu item and confirm.
s
Select MSN, e.g. MSN1: Anna.
v
Open the submenu.
r Ringer Melody: 5
Select melody and confirm, e.g. Ringer Melody: 5.
OK
OK
OK
OK
OK
OK