Siemens Gigaset C1 - Activating;Deactivating Repeater Mode

95
Operating with other devices
C1-C2 isdn / englisch / A31008-M373-B103-1-7619 / devices.fm / 08.06.2004
Activating/deactivating Auto engaged
When Auto engaged is activated, the exchange line becomes engaged as soon as the
receiver is picked up. This means that normal internal dialling is no longer possible.
However, an internal call can be made as an enquiry call by pressing the
S key.
Activating/deactivating repeater mode
You can increase the range of your handsets with the Gigaset Repeater. You can operate
up to six repeaters on your base. To ensure the repeater is installed correctly, repeater
mode must be activated on the base.
You can use this function to activate and deactivate repeater mode.
By factory default, this repeater capability is deactivated.
MENU
Press display key to open menu.
s Set base OK
Select the menu item and confirm.
s Settings OK
Select the menu item and confirm.
~ OK
Enter system PIN if required (page 78).
s Setup user OK
Select the menu item and confirm.
Setup device OK
Confirm.
sINT 21
Select the internal number, e. g., INT 1121.
MENU
Open the submenu.
s Auto. seizure OK
Select the menu item and confirm.
MENU
Press display key to open menu.
s Set base OK
Select the menu item and confirm.
s Settings OK
Select the menu item and confirm.
~ OK
Enter system PIN if required (page 78).
s System settings OK
Select the menu item and confirm.
s Spec. function OK
Select the menu item and confirm.
s Repeater OK
Select the menu item and confirm (‰ = activated).
OK
Press the display key to confirm the prompt.
a
Long press (back to idle status).