Siemens Gigaset C1 - Operating with a Gate Telephone; Assigning Internal Users to the Gate Telephone Call Group; Making Calls with the Gate Telephone

147
Operating with a gate telephone
S1_SL1 / englisch / A31008-M373-B103-1-7619 / door_intercom.fm / 08.06.2004
Operating with a gate telephone
Assigning internal users to the gate telephone call group
If you have set up a gate telephone, all internal users registered on the base will be
assigned to the gate telephone call group. You can change the assignment.
Making calls with the gate telephone
Call from the gate telephone
In a call with the gate telephone, the following performance features are not available:
◆ Putting a call on hold
◆ Making an enquiry call from a call with the gate telephone
◆ Toggling a user on the gate telephone
◆ Conference with a user on the gate telephone
◆ Forwarding or transferring a call from the gate telephone
The gate telephone calls internal users for 20 seconds. If call forwarding for the gate tel-
ephone is set up externally, the call time is extended to 60 seconds.
On the base:
SX205isdn SX255isdn SX303isdn SX353isdn
v
Open the menu.
sí
Select the menu item and confirm.
s Settings
Select the menu item and confirm.
~
Enter system PIN if required (page 91).
s Setup user
Select the menu item and confirm.
Setup device
Confirm.
s Int.11
Select internal user, e.g. Intern 11.
©
Open the submenu.
s Door call grp.
Select the menu item and confirm (‰ = On).
OK
OK
OK
OK
OK
OK
c
Press the talk key. You are connected to the gate tel-
ephone. The message
Door appears in the display.
... then
a
Press end call key.
or ...
[RRRRRRRRRRRRRRRRRRRRRRRRRR ]
OP DOOR
Press the display key to activate the door opener. The
door opener is activated. As confirmation, you
receive the screen display
Door is opening. The con-
nection to the gate telephone is automatically ended
after the door opens.