Siemens Gigaset C1 - Restoring the Factory Setting; Checking the Status

128
System settings
S1_SL1 / englisch / A31008-M373-B103-1-7619 / settings_bs.fm / 14.06.2004
Restoring the factory setting
You can select which type of reset should be performed:
Operational – All MSNs and access code are deleted and the AM PIN (on Gigaset with
integrated answering machine) is set to 0000. The authorisations are reset to "dial and
answer".
Reset all – All functions are reset to their factory defaults. The system PIN is reset to
"0000". All entries (calls list, charges) are deleted.
Checking the status
The status of the following settings can be checked:
◆ Callback
◆ Unknown call
◆ Call forwarding
◆ External connections
◆ AM1, AM2, AM3
i
The following applies to both functions: Before resetting, deactivate all
active call transfers! The handsets are still registered.
v
Open the menu.
sí
Select the menu item and confirm.
s Settings
Select the menu item and confirm.
~
Enter system PIN if required (page 91).
s System settings
Select the menu item and confirm.
s Spec. function
Select the menu item and confirm.
s Factory setting
Select the menu item and confirm.
either ...
Restore the functionality:
s Operational
Select the menu item and confirm.
or ...
Restore factory settings:
s Reset all
Select the menu item and confirm.
OK
OK
OK
OK
OK
OK
OK
OK
v
Open the menu.
sí
Select the menu item and confirm.
s Status
Select the menu item and confirm. The status list is
displayed (
‰ = activated).
OK
OK