158
Appendix
S1_SL1 / englisch / A31008-M373-B103-1-7619 / appendix.fm / 08.06.2004
PC interface
The SL 1 handset can be connected to your computer using a Siemens data cable
(page 168). Your computer can communicate with your Gigaset SL 1 using the program
"Siemens Data Suite" (download free of charge at
http:\\www.siemens-mobile.com\mysiemens) and can access the following parameters
and lists of the handset:
Reading out parameters
◆ SW version
◆ Type
◆ Manufacturer code
Read/write access to
◆ the directory
◆ the email directory
◆ the network provider list
◆ the list of appointments
◆ the last number redial list
Read/write access to other parameters
◆ Ringer settings
◆ Volume settings
◆ Loading melodies
◆ Make phone calls and answer calls
Data transmission
Large quantities of data are transferred between the handset and an external device
with a few functions. In this case, the handset switches to the data transmission mode,
Data Transfer is displayed on the screen. In this mode, the keyboard cannot be used to
enter data and incoming calls are ignored.
In the following cases, the handset switches to the data transmission mode:
◆ Read/write access to the directory
◆ Read/write access to the email directory
◆ Read/write access to the network provider list
◆ Read/write access to the list of appointments
◆ Read/write access to the last number redial list
◆ Loading melodies
If an error occurs during transfer, the handset switches to idle status:
Make phone calls and answer calls
If you select a number from an external device or accept a call from there, the handset
behaves exactly as if you had executed these functions on the handset.
On the MT:
SL1
To Next Page
Loading...
