Siemens Gigaset C1 - Operating with Other Devices; Setting Device Type; Making Calls with Devices on the Analogue Connection (TAE Connection)

To Next Page

To Previous Page

Operating with other devices

C1-C2 isdn / englisch / A31008-M373-B103-1-7619 / devices.fm / 08.06.2004

Operating with other devices

Setting device type

Making calls with devices on the analogue connection

(TAE connection)

Telephones with tone dialling (DTMF = dual tone multi-frequency dialling) can be oper-

ated on analogue connections. Telephones with pulse dialling are not supported.

at the base:

SX205isdn SX255isdn SX303isdn SX353isdn

Press display key to open menu.

s Set base OK

Select the menu item and confirm.

s Settings OK

Select the menu item and confirm.

~ OK

Enter system PIN if required (page 78).

s Setup user OK

Select the menu item and confirm.

Setup device OK

Confirm.

sINT 21

Select the internal number, e. g. INT 1121.

Open the submenu.

s Device type OK

Select the menu item and confirm.

sFax

Select a device type and confirm, e. g. Fax.

Open the submenu.

Save entry OK

Confirm. The name is now shown in the internal list,

including when an internal call is made from this

internal number.

If the setting is changed from a device type that does not require a receive

MSN to one that does, all MSNs that are programmed in the system will

be transferred as active receive MSNs for this internal user.

at the base:

SX205isdn SX255isdn SX303isdn SX353isdn

For notes on making calls with devices on the analogue connection,

please refer to the operator’s manual for the base.

Other manuals for Siemens Gigaset C1