Siemens Gigaset C1 - Activate;Deactivate Call Beats Data; Changing the Long Distance Prefix

126
System settings
S1_SL1 / englisch / A31008-M373-B103-1-7619 / settings_bs.fm / 14.06.2004
Activate/deactivate Call beats data
Using Call beats data you can set if a call is rejected or signalled during data transmis-
sion.
Your ISDN connection offers you 2 simultaneously usable telephone lines (B channels).
Both channels are used at the same time to transmit data.
◆ Call beats data off (factory setting):
Calls during data transmission are rejected. The caller hears the busy signal.
◆ Call beats data on:
When there are calls during data transmission, the data connection is automatically
reduced to one B channel and the call is signalled.
Changing the long distance prefix
Long distance prefixes are the first few digits required when dialling another city
(national) or to another country (international). In Germany, the factory default is:
In other countries, different long distance prefixes could be used. In this case you need
to change this setting.
Otherwise, you wouldn't be able to make some calls, such as ringbacks, from the call
list.
On the base:
SX205isdn SX255isdn SX303isdn SX353isdn
v
Open the menu.
sí
Select the menu item and confirm.
s Settings
Select the menu item and confirm.
~
Enter system PIN if required (page 91).
s ISDN settings
Select the menu item and confirm.
s Call beats data
Select the menu item and confirm (‰ = On).
OK
OK
OK
OK
OK
0 For connections to other towns (national)
00 For connections abroad (international)
v
Open the menu.
sí
Select the menu item and confirm.
s Settings
Select the menu item and confirm.
~
Enter system PIN if required (page 91).
s ISDN settings
Select the menu item and confirm.
s Lg.-dist. code
Select the menu item and confirm.
s National : 0
Select type of long distance prefix,
e.g. National : 0.
v
Open the submenu.
s Change number
Select the menu item and confirm.
OK
OK
OK
OK
OK
OK