9
Preparing to use the handset
C1-C2 isdn / englisch / A31008-M373-B103-1-7619 / starting.fm / 08.06.2004
Preparing to use the handset
Removing protective film
Inserting the batteries
◆ Insert the batteries ensuring correct polarity (see figure on left).
◆ Place the cover on the battery compartment about 3 mm down from the latch and
push it up until it clicks into position.
Opening the battery compartment
Press on the ribbed section of the cover and push the cover downwards.
Charging batteries
1. The charging is indicated in the upper right of the display where the charging status
V flashes:
The display is protected by a plastic film.
Please remove the protective film!
W
Gigaset C2:
Use only the rechargeable batteries recommended by Siemens on
page 103! i. e. never use conventional (non-rechargeable) batteries or
other battery types as this may cause significant damage to health and
property. For example, the jacket of the battery could be destroyed (haz-
ardous). The phone could also malfunction or be damaged.
= Batteries (almost) flat V Batteries
2
/
3
charged
e Batteries
1
/
3
charged U Batteries fully charged
i
To register handsets, refer to page 14.
To Next Page
Loading...
