Additional functions
115
PC interface (V24, USB)
You can use the PC interface (via a Slim Lumberg cable) to read and modify
phonebook entries, pictures and sounds.
Configuring the PC interface
To configure the PC interface, you must:
1. deactivate the Bluetooth interface on the handset (Æ Page 118).
2. use a Siemens data cable (Æ Page 132) to connect the headset/PC in-
terface jack on the handset to the computer.
3. install the MPM application.
For more information, consult your system administrator.
Data transfer mode
Certain functions necessitate the transfer of large volumes of data be-
tween the handset and the computer. When these functions are selected,
the handset switches to data transfer mode and "Data Transfer" appears on
the display. In this mode, no inputs are possible via the keyboard and calls
are ignored.
The handset is switched to data transfer mode by:
• activating read/write access to the phonebook
• loading screensavers
• loading melodies
Note:
If the PC interface does not work, first deactivate the Bluetooth in-
terface (Æ Page 118), then switch the handset off and back on.
Note:
The handset automatically switches to idle if a fault occurs in the
course of transferring data.
To Next Page
Loading...
Need help?
General