Siemens HiPath 3000 Operating Manual

Putting the handset into service
18
Procedure
1. Remove the attachment clip (if fitted)
Press the tongue on the attachment clip (1) and pull the attachment clip off
the stud (2).
2. Open the battery compartment
1. Use a suitable Allan key to loosen and remove the battery cover screw
(1).
2. Insert a suitable screwdriver into the recess between the housing and
the battery cover, twist it, and then raise the battery cover (2).
3. Slide the battery cover downwards away from the housing (3).
3. Insert/replace battery pack and memory card
1. Remove any old battery packs (1). If necessary, slide the memory card
out of the retainer and remove it (2). Lift the memory card out of the
positioning device.
2. Insert the memory card and slide it into the retainer until it snaps into
place (3). Make sure to line up the notched corner when positioning the
memory card in the retainer.
3. Insert the new battery pack [at a slant, head first and with the contacts
facing down] (4). Then press it down into the compartment until the
battery pack’s positioning clip firmly snaps into place (5).
1
2
1
2
3

Siemens HiPath 3000 Specifications

General

Brand	Siemens
Model	HiPath 3000
Category	Telephone
Language	English