Siemens HiPath C10 - Page 104

Configuring the wireless AP
A31003-W1040-U101-1-7619, July 2006 DRAFT
104 HiPath Wireless Controller, Access Points and Convergence Software V4.0, C10/C100/C1000 User Guide
hwc_apstartup.fm
Performing wireless AP software maintenance
To define parameters for a wireless AP controlled software upgrade:
1. From the main menu, click Wireless AP Configuration. The Wireless AP Configuration
screen appears.
2. From the left pane, click AP Maintenance. The AP Software Maintenance tab appears.
3. Click the Controlled Upgrade tab.
.
4. From the Select AP Platform drop-down list, select the type of AP you want to upgrade.
5. From the Select an image to use drop-down list, select the software image you want to
use for the upgrade.
6. In the list of registered Wireless APs, select the checkbox for each Wireless APs to be
upgraded with the selected software image.
7. Click Apply AP image version. The selected software image appears in the Upgrade To
column of the list.
>
The Controlled Upgrade tab will appear only when the Upgrade Behavior is set to
Upgrade when AP connects using settings from Controlled Upgrade on the AP
Software Maintenance tab.