Configuring the HiPath Wireless Controller
A31003-W1040-U101-1-7619, July 2006 DRAFT
44 HiPath Wireless Controller, Access Points and Convergence Software V4.0, C10/C100/C1000 User Guide
hwc_startup.fm
System configuration overview
The HiPath Wireless Controller is available in the following product families:
4.1 System configuration overview
The following section provides a high-level overview of the steps involved in the initial
configuration of your system:
Step 1 – Before you begin configuration
Research the type of WLAN deployment that is required.
Step 2 – Preparing the network
Ensure relevant DHCP servers and RADIUS servers (if applicable) are available and
configured.
C100 ● Four fast-Ethernet ports (10/100 BaseT),
supporting up to 75 Wireless APs
● One management port (10/100/1000 BaseT)
● One console port (DB9 serial)
● Power supply redundant (R)
C1000 ● Two GigE ports (dual 1GB SX network
interfaces) supporting up to 200 Wireless APs
● One management port (10/100/1000 BaseT)
● One console port (DB9 serial)
● Power supply redundant (R)
HiPath Wireless Controller
Model Number
Specifications
C2400 (Enterprise license) ● Four GigE ports supporting up to 200 wireless APs
● One management port (10/100 BaseT)
● One console port (DB9 serial)
● Power supply standard (R)
C2400 (Pro license) ● Four GigE ports supporting up to 100 wireless APs
● One management port (10/100 BaseT)
● One console port (DB9 serial)
● Power supply standard (R)
Table 3 HiPath Wireless Controller product families
HiPath Wireless Controller (Rev.2)
Model Number
Specifications
Table 2 HiPath Wireless Controller product families
To Next Page
Loading...
Need help?
General
