hwc_pref.fm
A31003-W1040-U101-1-7619, July 2006 DRAFT
HiPath Wireless Controller, Access Points and Convergence Software V4.0, C10/C100/C1000 User Guide
11
About this Guide
Documentation feedback
1.4 Documentation feedback
If you have any problems using this document, please contact your next level of support:
● Siemens employees should contact the interactive Customer Engagement Team (i-CET).
● Customers should contact the Siemens Customer Support Center.
When you call, please have the following information ready. This will help us to identify the
document that you are referring to.
● Title: HiPath Wireless Controller, Access Points and Convergence Software V4.0 C10/
C100/C1000 User Guide
● Part Number: A31003-W1040-U101-1-7619
1.5 Safety Information
Dangers
● Replace the power cable immediately if it shows any sign of damage.
● Replace any damaged safety equipment (covers, labels and protective cables)
immediately.
● Use only original accessories or components approved for the system. Failure to observe
these instructions may damage the equipment or even violate safety and EMC regulations.
● Only authorized Siemens service personnel are permitted to service the system.
Warnings
● This device must not be connected to a LAN segment with outdoor wiring.
● Ensure that all cables are run correctly to avoid strain.
● Replace the power supply adapter immediately if it shows any sign of damage.
● Disconnect all power before working near power supplies unless otherwise instructed by a
maintenance procedure.
● Exercise caution when servicing the hot swappable power supply of the HiPath Wireless
Controller (C100/C1000).
● Exercise caution when servicing hot swappable HiPath Wireless Controller components:
power supplies or fans. Rotating fans can cause serious personal injury.
To Next Page
Loading...
Need help?
General
