Configuring the wireless AP
A31003-W1040-U101-1-7619, July 2006 DRAFT
98 HiPath Wireless Controller, Access Points and Convergence Software V4.0, C10/C100/C1000 User Guide
hwc_apstartup.fm
Modifying a wireless AP’s properties based on a default AP configuration
8. In the RF Domain ID box, type a string that uniquely identifies a group of APs that
cooperate in managing RF channels and power levels. The maximum length of the string
is 15 characters.
9. From the Minimum drop-down list, select the minimum power level that the range of
transmit power can be adjusted dynamically.
10. From the Maximum drop-down list, select the maximum power level that the range of
transmit power can be adjusted dynamically.
11. Click Apply to selected APs.
12. To save your changes, click Save.
13. To re-establish baseline settings, forcing the APs to go through the auto-channel selection
process, click Reset DRM.
5.6 Modifying a wireless AP’s properties based on a default AP
configuration
If you have a wireless AP that is already configured with its own settings, but would like the
wireless AP to be reset to use the system’s default AP settings, use the Reset to Defaults
feature on the AP Properties tab.
To configure a wireless AP with the system’s default AP settings:
1. From the main menu, click Wireless AP Configuration. The HiPath Wireless AP screen
appears.
2. In the wireless AP list, click the wireless AP whose properties you want to modify. The AP
Properties tab displays wireless AP information.
3. Click Reset to Defaults to have the wireless AP inherit the system’s default AP settings. A
pop-up window asking you to confirm the configuration change appears.
4. Click OK to confirm resetting the AP to the default settings.
5.7 Modifying the wireless AP’s default setting using the Copy to
Defaults feature
You can modify the system’s default AP settings by using the Copy to Defaults feature on the
AP Properties tab. This feature allows the properties of an already configured AP to become
the system’s default AP settings.
>
If SSID Broadcast is disabled and DRM is enabled, you must provide an RF
Domain ID.
To Next Page
Loading...
Need help?
General
