Siemens HiPath C10 - Saving Your Topology Properties; Assigning Wireless AP Radios to a VNS

hwc_vnsconfiguration.fm
A31003-W1040-U101-1-7619, July 2006 DRAFT
HiPath Wireless Controller, Access Points and Convergence Software V4.0, C10/C100/C1000 User Guide
133
Virtual Network configuration
Assigning Wireless AP radios to a VNS
4. Configure the topology for your VNS accordingly. For more information, see Section 7.1,
“Topology for a VNS”, on page 124.
5. To save your changes, click Save.
7.1.3 Saving your topology properties
Once your topology is defined, you can then save your topology properties to continue
configuring your VNS. To save your topology properties, click Save.
7.2 Assigning Wireless AP radios to a VNS
If two HiPath Wireless Controllers have been paired for availability (for more information, see
Section 8.1, “Availability overview”, on page 189), each HiPath Wireless Controller's registered
Wireless APs will appear as foreign in the list of available Wireless APs on the other HiPath
Wireless Controller.