Virtual Network configuration
A31003-W1040-U101-1-7619, July 2006 DRAFT
130 HiPath Wireless Controller, Access Points and Convergence Software V4.0, C10/C100/C1000 User Guide
hwc_vnsconfiguration.fm
Topology for a VNS
● In the DHCP Address Exclusion subscreen, do one of the following:
● To specify an IP range, type the first available address in the From box and type
the last available address in the to box. Click Add for each IP range you provide.
● To specify a IP address, select the Single Address option and type the IP address
in the box. Click Add for each IP address you provide.
● To save your changes, click Save. The DHCP Address Exclusion subscreen closes.
5. The Broadcast Address box populates automatically based on the Gateway IP address
and subnet mask of the VNS.
6. In the Domain Name box, type the external enterprise domain name.
7.1.1.6 Modifying time limits for IP assignments
The following procedure is only applicable for configurations if the controller is the DHCP server
for users in the VNS—a routed VNS or a VLAN bridged VNS with DHCP enabled (by default,
DHCP is disabled). These values are not visible for a bridged at AP VNS or a VLAN bridged
VNS with DHCP disabled (by default, DHCP is disabled).
Time limits for IP assignments dictate the default and the maximum time limits a wireless device
can keep the DHCP server-assigned IP address.
To Next Page
Loading...
