Siemens HiPath C10 User Manual

hwc_vnsconfiguration.fm
A31003-W1040-U101-1-7619, July 2006 DRAFT
HiPath Wireless Controller, Access Points and Convergence Software V4.0, C10/C100/C1000 User Guide
169
Virtual Network configuration
Configuring privacy for a VNS
To configure privacy by WPA-PSK for a Captive Portal VNS
1. From the main menu, click Virtual Network Configuration. The Virtual Network
Configuration screen appears.
2. In the left pane Virtual Networks list, click the VNS you want to configure privacy by WPA-
PSK for a Captive Portal. The Topology tab is displayed.
3. Click the Privacy tab.
4. Select WPA-PSK.
5. To enable WPA v1 encryption, select WPA v.1.
6. If WPA v.1 is enabled, select one of the following encryption types from the Encryption
drop-down list:
● Auto – The AP will advertise both TKIP and CCMP (Counter Mode with Cipher Block
Chaining Message Authentication Code Protocol) for WPAv1. CCMP is an IEEE
802.11i encryption protocol that uses the encryption cipher AES (Advanced
Encryption Standard). Auto is the default.
● TKIP only – The AP will advertise TKIP as an available encryption protocol for WPAv1.
It will not advertise CCMP.
7. To enable WPA v2-type encryption, select WPA v.2.

Siemens HiPath C10 Specifications

General

Brand	Siemens
Model	HiPath C10
Category	Controller
Language	English