hwc_regulatory_information.fm
A31003-W1040-U101-1-7619, July 2006 DRAFT
HiPath Wireless Controller, Access Points and Convergence Software V4.0, C10/C100/C1000 User Guide
19
Regulatory information
AP2610 Internal Antenna AP, AP2620 External Antenna AP
● This device may not cause harmful interference.
● This device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a residential and
business environment. This equipment generates, uses, and radiates radio frequency energy,
and if not installed and used in accordance with instructions, may cause harmful interference.
However, there is no guarantee that interference will not occur. If this equipment does cause
harmful interference, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment or devices.
● Connect the equipment to an outlet other than the receiver's.
● Consult a dealer or an experienced radio/TV technician for suggestions.
This equipment meets the following conformance standards:
USA Conformance Standards
Safety
● UL 60950-1:2003, 1st Edition
● UL 2043 Plenum Rated as part of UL 60950. Suitable for use in environmental air space in
accordance with Section 300.22.C of the National Electrical Code.
EMC
● FCC CFR 47 Part 15, Class B
Radio Transceiver
● FCC ID: REB-APXXX1
● CFR 47 Part 15.247, Subpart C (2.4 GHz)
● CFR 47 Part 15.407, Subpart E (5 GHz)
Other
● IEEE 802.11a (5 Ghz)
● IEEE 802.11b/g (2.4 GHz)
To Next Page
Loading...
Need help?
General
