hwc_ongoing.fm
A31003-W1040-U101-1-7619, July 2006 DRAFT
HiPath Wireless Controller, Access Points and Convergence Software V4.0, C10/C100/C1000 User Guide
263
Performing system maintenance
Performing HiPath Wireless Controller software maintenance
● Reboot due to failure
● Software upgrade failure on the HiPath Wireless Controller
● Software upgrade failure on the Wireless AP
● Detection of rogue access point activity without valid ID
If SNMP is enabled on the HiPath Wireless Controller, alarm conditions will trigger a trap in
SNMP (Simple Network Management Protocol). An SNMP trap is an event notification sent by
the managed agent (a network device) to the management system to identify the occurrence
of conditions. (For more information, see Section 9.4, “Setting up SNMP”, on page 159.)
To view logs:
1. From the main menu, click Logs & Traces. The Logs & Traces screen appears.
2. In the Navigation bar, click one of the Log tabs. The selected Log screen appears. The
following is an example of the HiPath Wireless Controller logs:
The events are displayed in chronological order, sorted by the Timestamp column.
3. To sort the display by Type or Component, click the appropriate column heading.
To Next Page
Loading...
