Configuring the wireless AP
A31003-W1040-U101-1-7619, July 2006 DRAFT
74 HiPath Wireless Controller, Access Points and Convergence Software V4.0, C10/C100/C1000 User Guide
hwc_apstartup.fm
Discovery and registration overview
The table below assumes the software uses a timer and multiple phases to simulate LED
blinking on all three LEDs. For example, an LED status of Red indicates the LED is solid colored
Red, an LED status of Off/Green/Off indicates that the LED is Off for the first phase, Green for
the second phase, and Off for the third phase.
Left LED
Status
Center LED
Status
Right LED
Status
AP Status
Off Off Off Powered-off
Off Green Off Beginning of Power-On-Self-Test
(POST) (0.5 seconds)
Off Off Off POST
Off Red Off Failure during POST
Green Off Green Random delay – State displayed only
after a vulnerable reset
Green/Off Off/Green Green/Off Vulnerable time interval – The Wireless
AP resets to factory default if powered-
off for three consecutive times during
this state. No vulnerable period when
AP is resetting to factory defaults.
Green/Off/
Off
Off/Green/Off Off/Off/Green Resetting to factory defaults
announcement – Replaces vulnerable
period. This pattern is repeated twice
to notify the operator when the factory
configuration is restored.
Off Orange
(Green + Red)
Off Attempting to obtain an IP address via
DHCP.
Off Red/Orange Off No DHCP reply has been received.
Off Green/
Orange
Off Failed discovery (SLP).
Off Off/Orange Off HiPath Wireless Controller has been
discovered. Registering the AP.
Off Off/Red Off Registration of the AP has failed.
Off Off/Green Off Standby, registered with a HiPath
Wireless Controller, waiting for
configuration.
To Next Page
Loading...
