Siemens HiPath C10 - Page 87

hwc_apstartup.fm
A31003-W1040-U101-1-7619, July 2006 DRAFT
HiPath Wireless Controller, Access Points and Convergence Software V4.0, C10/C100/C1000 User Guide
87
Configuring the wireless AP
Modifying wireless AP settings
3. Modify the Wireless AP’s information:
● Name – Type a unique name for the Wireless AP that identifies the Wireless AP. The
default value is the Wireless AP’s serial number.
● Description – Type comments for the wireless AP.
● Port # – Select the Ethernet port of the controller the wireless AP is connected to.
● Poll Timeout – Type the timeout value, in seconds, for polling the controller. The
default value is 10 seconds.
● Poll Interval – Type the interval value, in seconds, for polling the controller. The default
value is 2 seconds.
● Telnet Access – Select whether Telnet Access to the wireless AP is enabled or
disabled.
● Maintain client session in event of poll failure – Select this option if the AP should
remain active if a link loss with the controller occurs.This option is enabled by default.