hwc_apstartup.fm
A31003-W1040-U101-1-7619, July 2006 DRAFT
HiPath Wireless Controller, Access Points and Convergence Software V4.0, C10/C100/C1000 User Guide
95
Configuring the wireless AP
Modifying wireless AP settings
3. Click the Static Configuration tab.
4. Select one of the VLAN settings for the wireless AP:
● Tagged - VLAN ID – Select if you want to assign this AP to a specific VLAN and type
the value in the box.
● Untagged – Select if you want this AP to be untagged. This option is selected by
default.
5. Select one of the two methods of IP address assignment for the wireless AP:
● Use DHCP – Select this option to enable Dynamic Host Configuration Protocol
(DHCP). This option is enabled by default.
● Static Values – Select this option to specify the IP address of the wireless AP.
● IP Address – Type the IP address of the AP.
● Subnet Mask – Type the appropriate subnet mask to separate the network portion
from the host portion of the address.
● Gateway – Type the default gateway of the network.
To Next Page
Loading...
