Siemens LDS 6 - Page 43

come from the sensor connection cable. A detailed connection information can be obtained
from sectionConnection diagrams (Page44).
1. Connect the green wire next to the red wire on the connector.
2. Connect the brown wire next to the black wire on the connector.
3. Connect the optics housings, on both the transmitter and the receiver side, to earth using the
pre-mounted 2meter potential equalizing cable (yellow-green).
Electric connections
4.2Connecting the LDS 6, optics housing CD 6
LDS 6 & Optics housing CD 6 Compact Operating Instructions
Compact Operating Instructions, 12/2022, A5E03314905-AB 43