Siemens LDS 6 - Page 42

3. Connect each hybrid cable to the surge protection device.
Minus (brown cable) shall be connected to terminal number 4 and plus (green cable) to
terminal number 5.
4. Connect the hybrid cable to the transmitter optics housing.
WARNING
Sparkovers
To prevent sparkovers in a multi-channel barrier box that is equipped with one surge
protection device for each channel the distance between each other must be >2mm.
+\EULGFDEOHIURP/'6FHQWUDOXQLW
+\EULGFDEOHWRRSWLFVKRXVLQJ&'
6XUJHSURWHFWLRQFRQQHFWHGWR
JURXQGYLD',1UDLO
/HDYHVXUJHSURWHFWLRQ
WHUPLQDOVDQGRSHQ
%DUULHUGHYLFH
,QEDUULHUER[HVHTXLSSHGZLWK
PRUHWKDQRQHVXUJH
SURWHFWLRQPDNHVXUHWKDWWKH
GLVWDQFHEHWZHHQHDFKRWKHU
LVPRUHWKDQPP
Figure4-5 Connections inside the barrier box
Connecting receiver to transmitter optics housing
The connector mounted on the sensor card is already connected with a red wire for + and
a black wire for –. Two additional wires should be connected to the connector. These wires
Electric connections
4.2Connecting the LDS 6, optics housing CD 6
LDS 6 & Optics housing CD 6 Compact Operating Instructions
42 Compact Operating Instructions, 12/2022, A5E03314905-AB