Siemens LME39.100C2 - Type Summary and Accessories; Type summary (other types on request)

16/73
Building Technologies Division Basic Documentation LME39… CC1P7106en
4 Type summary (other types on request) 08.12.2017
4 Type summary (other types on request)
The product nos. given below applies to the LME39… without plug-in base and without flame detector. For ordering information on plug-in bases and other accessories, refer to
Ordering.
Article no. Type
Times in seconds
tw
max.
s
TSA
max.
s
tfz
(P228)
approx.
s
t1
(P225)
min.
s
t1'
(P256)
min.
s
t3
(P226)
approx.
s
t3n
(P257)
approx.
s
t4
(P230)
approx.
s
t8
(P234)
min.
s
t10
(P224)
approx.
s
t11
(P259)
min.
s
1)
t12
(P260)
min.
s
1)
t22
(P231)
max.
s
BPZ:LME39.100C1 LME39.100C1
Requirement 2.5 3 0.3 30 --- 3 2.5 10 0 180 30 30 ---
BPZ:LME39.100C2 LME39.100C2
Requirement 2.5 3 0.3 30 --- 3 2.5 10 0 180 30 30 ---
Setting range
Min. --- 0.3 0 0 --- 1.2 0 + 0.3 1.2 0 0 0 0 ---
Max. --- 37.5 + 1.5 + 0.3 1.5 75 --- 37.5 37.5 + 0.3 75 1237 179.5 75 75 ---
Increments (s) --- 0.147 0.147 0.294 --- 0.147 0.147 0.294 4.851 4.851 0.294 0.294 ---
Factory setting --- t3n + tfz 0.294 32.34 --- 3.234 2.205 + 0.3 9.996 0 179.487 32.34 32.34 ---
BPZ:LME39.400C1 LME39.400C1
Requirement 2.5 5 0.3 --- 14.5 1.7 4.4 10 0 --- --- --- 5
BPZ:LME39.400C2 LME39.400C2
Requirement 2.5 5 0.3 --- 14.5 1.7 4.4 10 0 --- --- --- 5
Setting range
Min. --- 0.3 0 --- 0 1.2 0 1 0 --- --- --- 0
Max. --- 37.5 + 1.5 + 0.3 1.5 --- 75 37.5 37.5 + 0.3 75 1237 --- --- --- 7.4
Increments (s) --- 0.147 0.147 --- 0.294 0.147 0.147 0.294 4.851 --- --- --- 0.147
Factory setting --- t3n + tfz 0.294 --- 15.582 1.911 4.116 + 0.3 9.996 0 --- --- --- 4.557
Function parameter Parameter number Factory setting
Repetition limit value loss of flame and no flame at the end of safety time
0 = none
1 = none
2 = 1 x repetition
3 = 2 x repetition
4 = 3 x repetition
240 1