Siemens LME39.100C2 - Parameters with index, with or without direct display; Example of parameter 701 (actual error) on the service level

63/73
Building Technologies Division Basic Documentation LME39… CC1P7106en
20 Operating variants of the parameters 08.12.2017
20.3 Parameters with index, with or without
direct display
20.3.1 Example of parameter 701 (actual error) on the service
level
Refer to chapter Error code list!
P
Vhmins%
Bild 177/1107
Press
to select parameter 701.
Display: Parameter 701. flashes, index 01: and error
code 4 do not.
P
Vhmins%
Bild 177/1107
On the left, the current error 701. appears flashing, index
01: does not flash.
On the right, error code 4 is displayed.
Example:
Parameter 701., index 01:, error code 4
/
reset
1…3 s
P
Vhmins%
Bild 178/1107
Press
/
reset
for 1…3 seconds to show index 01: for the
error code flashing.
Display: Parameter 701. does not flash, index 01: flashes,
error code 4 does not flash.
To the next index
P
V
hmins %
Bild 179/1107
Press
to select the index.
.01 = error code
.02 = diagnostic code
Example:
Parameter 701., index 02:, diagnostic code ._._
/
reset
1…3 s