LOGO! manual
EWA 4NEB 712 6006-02
46
The cursor indicates your position
in the program.
Q1
At this point, enter only the first block (the OR block). Press the OK key
to switch to input mode.
The cursor appears in the form of
a solid block: You can select a
connector or block.
Q1
Co
The cursor no longer appears in the form of an underline; instead, it ap-
pears as a solid block that flashes on and off. At the same time, LOGO!
offers you the first list for selection. Select the GF list (by pressing the
key until GF appears), and press the OK key. LOGO! then displays the
first block in the list of basic functions:
The first block in the list of basic
functions is AND. The cursor ap-
pears in the form of a solid block,
indicating that you have to select
a block.
&
B01
Q1
Press the or key until the OR block appears in the display:
1
The cursor is still in the block and
appears in the form of a solid
block.
B01
Q1
Press the OK key, and conclude your entry.
Programming LOGO!
To Next Page
Loading...
