47
LOGO! manual
EWA 4NEB 712 6006-02
1
The following appears in the display panel
B01
Q1
B01
1
Q1
Your program looks like this
Block number
You have now entered the first block. Every block you enter receives a
number, the block number. All you have to do now is wire the inputs of
the block. To do this:
Press the OK button:
1
The following appears in the display panel
B01
Q1
B01
1
Q1
Your program looks like this
Co
Select the Co list: Press the OK key
1
The following appears in the display panel
B01
Q1
B01
1
Q1
Your program looks like this
x
The first item in the Co list is the character for indicating that an input is
not used, an ”x”. Use the or key to select input I1.
1
Q1
I1
Press the OK key: I1 is connected to the input of the OR block. The cursor
jumps to the next input of the OR block.
Programming LOGO!
To Next Page
Loading...
