Please note that Siemens provides customers with the optical
trigger signal output for research purposes only. No devices
connected to this output have been tested by Siemens. Before
connecting devices to the MR suite using the optical trigger
signal output, they must be tested for safety by trained
personnel.
Before using devices in the proximity of the magnet, their non-
magnetic properties and clinical operation in the magnetic field
must be confirmed.
The use of devices connected to the optical trigger signal output
must comply with any applicable governmental or local hospital
Institutional Review Boards (IRBS).
Siemens will not be held responsible for the use of any device
and resulting consequences in connection with the optical trigger
signal output.
The system separator contains electronics components and cooling-
equipment to deliver an adequate cooling power for the system. If a
special cooling system (chiller) is installed, the system separator is not
necessary.
The RF power amplifier provides the radio frequency signals for the
MR measurement.
RF coils
The description, handling and quality measurements for RF coils are
included in a separate operator manual. See: Coil operator manual
System separator
RF power amplifier (3T systems
only)
3.1.4
MR system components 3
MAGNETOM Avanto, MAGNETOM Verio | syngo MR E11
51
Print No. MR-01501G.621.02.02.02
To Next Page
Loading...
