To use the holder for infusion bottles, position the rod on the left side
at the head end of the patient table.
Operation
The patient table can be controlled via the buttons on the control
unit.
Please note that this section only describes the operation of the
patient table. For details on positioning the patient, see: Operator
Manual Coils
To operate the patient table safely and efficiently, operating
personnel must be familiar with its most important positions.
Home position
Table is at the height of moving into the magnet bore, tabletop is
moved completely out of the magnet
Last scan position If the tabletop was moved only in the horizontal direction, the tab-
letop can be returned into the position of the last measurement
Default position The center of the Head Matrix is in the magnet isocenter
Center position The body region to be measured is in the magnet isocenter
Relative position Distance between the slice marked with the light localizer and the
magnet isocenter
The relative position and the actual tabletop movement are shown on
the table display.
For some measurements, the tabletop is moved automatically.
Holder for infusion bottles
3.4.2
MR system components 3
MAGNETOM Avanto, MAGNETOM Verio | syngo MR E11
61
Print No. MR-01501G.621.02.02.02
To Next Page
Loading...
