Siemens MAMMOMAT 300 - Laying the cable harness

Siemens-Elema AB SPS-UD RX B7-120.033.01.10.02 MAMMOMAT 300
Solna, Sweden 05.98 65 02 186
4-4 Installing the generator and the stand
Laying the cable harness
NOTE!
Remove the transport safeguards which consists of cable ties (four around the cable har-
ness and one around each shield cable end).
1 Separate the cable harness.
2 Lay the stand cable harness in the cable duct, as shown in Figure 4, all the way to the
generator.
Figure 4 Laying the cable harness
The cable harness consists of four shield cables, see Figure 4.
Pos in fig. 4 Description
1 High voltage cable H1.
2 IONTOMAT signal cable X11.
Unit control cable X1.
Power supply cable X14.
3 Anode rotation cable X9.
Filament cable X8.
4 Mains supply cables:
L1
L2
Protective ground.
MAM00092
1
2
3
4
MAM00087
5
2
1
3
4