Siemens MAMMOMAT 300 - Connecting the cable harness to the generator

Siemens-Elema AB SPS-UD RX B7-120.033.01.10.02 MAMMOMAT 300
Solna, Sweden 05.98 65 02 186
5-6 Cable connections
Connecting the cable harness to the generator
NOTE!
Required EMC measures are described on page 1 in this section.
Figure 6 Cable harness at the generator
Unit control cable X1
1 Connect the unit control cable X1 to D700 X1 (1).
Filament cable X8
1 Connect the filament cable X8 to D700 X8 (2).
Power supply cable X14
1 Connect the power supply cable X14 to D711 X14 (3).
2 Strain relieve it on the side with a cable tie (4).
IONTOMAT signal cable X11
1 Connect the IONTOMAT signal cable connector X11, to D700 X11 (5).
MAM00102
2
1
5
3
F10 F20
F1
F2
F3
F4
4
F5
X32 X5 T3/X30