Siemens-Elema AB SPS-UD RX B7-120.033.01.10.02 MAMMOMAT 300
Solna, Sweden 05.98 65 02 186
Cable connections 5-7
Rotating anode cable X9
Figure 7 Connecting X9 to the generator
1 Connect the rotating anode cable X9 to D711 X9 (1).
2 Connect the two blue free wires from connector D711 X9 (1) to capacitor C51 (2).
3 Fit the cable to the chassis by using a cable clamp (3).
CAUTION!
When fitting the cable clamp, ensure satisfactory contact between shield braid (4) and
chassis.
2
1
MAM00163
4
3
To Next Page
Loading...
