Siemens-Elema AB SPS-UD RX B7-120.033.01.10.02 MAMMOMAT 300
Solna, Sweden 05.98 65 02 186
0-2 Installation and Start-Up Instructions
Connecting the cable harness to the generator 5-6
Mains connection 5-8
Connecting the incoming mains to the
stand (400 V, 2-phase) 5-8
400 V 2-phase connection 5-8
Connecting the mains supply to the generator 5-9
Measures for changing from 2-phase to 1-phase connection 5-10
6 Modifying the object tables 6-1
Modifying the object tables 18 cm x 24 cm for thick cassettes 6-1
Modifying the object tables 24 cm x 30 cm for thick cassettes 6-2
7 Mains connection and power supply 7-1
Checks before powering up the generator 7-1
Measuring the line resistance 7-1
Checking the line voltage in the generator 7-2
Checking the supply voltages 7-3
8 Attaching the swivel-arm covers 8-1
Attaching the swivel-arm covers 8-1
Arranging the swivel-arm system 8-1
Connecting the cables to control-button board and
patient handles 8-1
Attaching the covers 8-2
9 Checking the microprocessors 9-1
Microprocessors 9-1
10 Checks without high voltage 10-1
Checks without high voltage 10-1
11 Checks with high voltage 11-1
Preparation 11-1
Checking x-ray tube high voltage, tube current and
mAs values 11-2
Tube current reduction 11-2
Oscilloscope diagrams 11-3
12 Start-up and functional test of the IONTOMAT 12-1
Checking and programming with the service PC 12-1
Sensitivity 12-1
Sensitivity correction 12-2
Correction curve 12-2
Table of contents, Revision status
To Next Page
Loading...
