Prerequisites
A MindConnect device e.g. MindConnect IoT2040
A fat32 formatted USB stick
Procedure
To use a USB command, proceed as follows:
1. Make sure your USB stick is fat32 formatted.
2. Create a file named “ConBox_Commands.json” directly on the USB stick.
3. Open the “ConBox_Commands.json” file in a text editor.
4. Enter one of the "JSON Code" commands that you want to execute.
5. Save the changes to the "ConBox_Commands.json".
6. Plug the USB STick into the MindConnect device.
The following list shows various USB commands:
Copy extended logs to USB stick
The following command will collect all agent logs & system files, put them into
and files and copy them to the USB
stick.
ConBox_<UID>_
Logs.tar.gz ConBox_<UID>_SystemFiles.tar.gz
JSON Code:
{
"Commands": [
{
"Cmd":"CopySystemFilesToUsbStick",
"TypeOfFiles": "AllSystemFiles"
},
{
"Cmd":"CopyAgentLogsToUsbStick"
}
]
}
For the MindConnect IoT2040 it can take up to 15 minutes to collect all files.
Copy archived logs to USB stick
Some Logs arrive every day at approx. 0 UTC. The extended logs therefore only contain the data
of the current day. To get those logs for past days you need to run this command.
To Next Page
Loading...
