Step by Step
Enhanced phone functions
70
Announcement (broadcast) to all members of
a line trunk group
You can use this function to send an announcement to
all members (10 - 40) of a line trunk group.
Z Once you have activated the group call, you will hear a
confirmation tone. You can then begin the announce-
ment.
^ Lift the handset.
or
n Press the key and enter speakerphone mode.
j Enter the system code for "Speaker call-1-way bcst"
(contact the relevant service personnel if necessary).
or
S Press the "Broadcst Spk" programmed sensor key.
j Enter the internal phone number of a group member.
Z The loudspeakers on all group phones are automatically
switched on and you will hear a confirmation tone. You
can begin the announcement.
\ You end the announcement by replacing the handset.
^ If a group member lifts their handset, they are connect-
ed to you and the announcement is ended.
n or S If a group member presses the speaker key or the rele-
vant line key for the announcement, they are discon-
nected from the announcement. If the last remaining
member of the group presses the speaker key or line
key, the announcement ends.
Enter code!
To Next Page
Loading...
